Printronix P7000 Manual De Usuario
130
Chapter
7
Diagnosing Problems
Fault Messages Requiring Field Service Attention
If a fault is not correctable by the operator, the fault message is followed by an
asterisk (*). This usually indicates that an authorized service representative is
needed. You may try two steps to clear the fault before calling your authorized
service representative:
asterisk (*). This usually indicates that an authorized service representative is
needed. You may try two steps to clear the fault before calling your authorized
service representative:
1.
Set the printer power switch to O (Off), wait 15 seconds, then turn the
printer on again. Run your print job again. If the message does not
appear, it was a false indication and no further attention is required.
printer on again. Run your print job again. If the message does not
appear, it was a false indication and no further attention is required.
2.
If the message reappears, press the CLEAR key. If the message
disappears, it was a false indication and no further attention is required. If
the message reappears, call your authorized service representative.
disappears, it was a false indication and no further attention is required. If
the message reappears, call your authorized service representative.
Table 12. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation
Solution
06 HOST REQUEST
Yes
Host attention message.
The host computer or printer
controller requires attention.
controller requires attention.
08 HOLD PRINT
TIMEOUT
TIMEOUT
Yes
Printer was offline more than
10 minutes, and the
“Intervention Required”
parameter is set to “Send to
Host.”
10 minutes, and the
“Intervention Required”
parameter is set to “Send to
Host.”
Press ON LINE to put printer in
online state.
online state.
8.5V PWR FAIL*
No
8.5 Volt power failed.
Internal power failure.
Internal power failure.
Contact your authorized service
representative.
1
15 COMM CHECK
Yes
A message that appears in
the CT emulation meaning
the line is not active on a
twinax interface.
the CT emulation meaning
the line is not active on a
twinax interface.
Check cable connection.
15V CTL FAIL*
No
Controller voltage failure.
Contact your authorized service
representative.
1
22 INVALID ADDR
Yes
Unit address not recognized
by printer. (Twinax interface)
by printer. (Twinax interface)
Ensure that printer address
matches host setting.
matches host setting.
23.5V CTL FAIL*
No
23.5 Volt Controller failed: a
voltage failure on the
controller board.
voltage failure on the
controller board.
Contact your authorized service
representative.
1
31 PAPER OUT
TIMEOUT
TIMEOUT
Yes
A timeout message is sent to
the host if paper is not
loaded 10 minutes after
CLEAR was pressed to clear
the paper out fault.
the host if paper is not
loaded 10 minutes after
CLEAR was pressed to clear
the paper out fault.
Load paper and run a print test.
If the message reappears,
contact your authorized service
If the message reappears,
contact your authorized service
representative.
1
32 PAPER JAM
TIMEOUT
TIMEOUT
Yes
A timeout message is sent to
the host if no paper motion
has occurred for 10 minutes
after CLEAR was pressed to
clear the jam fault.
the host if no paper motion
has occurred for 10 minutes
after CLEAR was pressed to
clear the jam fault.
Clear paper jam and reload
paper.
paper.