Toshiba 46vx700u Guía Del Usuario

41) During normal use, the TV may make occasional 

snapping or popping sounds. This is normal, especially 
when the unit is being turned on or off. If these sounds 
become frequent or continuous, unplug the power cord 
and contact a Toshiba Authorized Service Center.

42)

Never strike the screen with a sharp 
or heavy object.

43) • The LCD screen of this product can be damaged by 

ultraviolet radiation from the sun. When selecting a 
location for the television, avoid locations where the 
screen may be exposed to direct sunlight, such as in 
front of a window.

• Never touch, press, or place anything on the LCD 

screen. These actions will damage the LCD screen. If 
you need to clean the LCD screen, follow the 
instructions in item 35 on p. 4.

Service

44)

Never attempt to service the TV yourself. Opening and 
removing the covers may expose you to dangerous 
voltage or other hazards. Failure to follow this 
WARNING may result in death or serious injury. Refer all 
servicing not specified in this manual to a Toshiba 
Authorized Service Center.

45) If you have the TV serviced:

• Ask the service technician to use only replacement 

parts specified by the manufacturer.

• Upon completion of service, ask the service 

technician to perform routine safety checks to 
determine that the TV is in safe operating condition.

Choosing a location for your LCD TV

To Display your LCD TV on the included Pedestal 
Stand:

Observe the following safety precautions:
1)

Read and Follow the pedestal assembly instructions 
included with the pedestal.
CAUTION:

 Before beginning pedestal assembly, 

carefully lay the front of the LCD Panel face down on a 
flat, cushioned surface such as a quilt or blanket. 
Leave the bottom of the unit protruding over the edge 
of the surface and assemble the pedestal as indicated 
below.
Note: 

2)

Place the TV on a sturdy, level surface that can support 
the weight of the TV.

3)

Be sure to secure the TV to a wall stud, pillar, surface, 
or other immovable structure. To secure the TV in this 
manner: (1) attach the provided securement clip to an 
immovable structure, then (2) pass a sturdy strap 

through the securement clip and attach each end to 
the hooks located on the back of the TV. Be sure to 
leave at least 4 inches between the TV and the wall or 
similar structure for ventilation. See item 25, p. 4 for 
additional details.

To Display your LCD TV using a Wall Bracket:

If you decide to wall mount your LCD TV, always use a UL 
Listed wall bracket appropriate for the size and weight of 
the LCD TV (

- p. 2) :

 

1. Two people are required for installation.
2. Never use the screws attached to the TV.
3. To install a wall-mount from another manufacturer, use 

the enclosed SPACERS.

1)

Unplug and remove any cables and/or other 
component connectors from the rear of the TV.

2)

Carefully lay the front of the unit face down on a flat, 
cushioned surface such as a quilt or blanket.

3)

Follow the instructions provided with your wall 
bracket. Before proceeding, make sure the 
appropriate bracket(s) are attached to the wall and the 
back of the TV as described in the instructions 
provided with the wall bracket.

4)

Make sure to place the spacers provided with the TV 
between the bracket and the back of the TV.

5)

Always use the screws supplied or recommended by 
the wall mount manufacturer.

Removing the Pedestal Stand

1)

Carefully lay the front of the unit face down on a flat, 
cushioned surface such as a quilt or blanket. Leave the 
stand protruding over the edge of the surface.
Note: 

2)

Remove the five screws.

3)

Once you have removed all five 
screws holding the pedestal 
stand in place, remove the 
pedestal stand from the TV by 
sliding the pedestal stand away 
from the TV.

1. Remove the four screws. 
(Do not use these for attaching 
a wall bracket.)

2. Place the four spacers (supplied).

Screw

Wall bracket

TV back panel

Five screws

VX700U_EN.pdf   5

2010/08/11   9:27:54