Netopia 3220-h Guía Del Usuario
Cayman 3220-H User’s Guide
Diagnostic Console
December 2000
B-7
revert
The
revert
command retrieves the saved version of settings from
non-volatile storage and overwrites any changes made since the last
save.
save.
save
The
save
command saves the EPROM settings you have entered or
changed to non-volatile storage in the Cayman 3220-H.
show
The
show
command displays the current EPROM settings for the
Cayman 3220-H and a brief explanation of those settings. For
example, the show command produces the following:
example, the show command produces the following:
BootPROM> show
flash on
(flash will be tried)
ip 0
(no ip address; tftp will not be tried)
file <unset>
(must be set for tftp download)
bootp on
(will attempt configuration via bootp)
autoboot 10
(will autoboot on powerup, and will try
10 times)
autoprog never
(will never program a downloaded
image into flash)
Cayman 3220-H serial no. 800700, h/w rev. 1, eprom v1.3
Last install status: code flash successfully programmed
flash image 1: Cayman 3220-H 5.3.0
Boot Setting
Commands
Commands
The following commands specify boot settings for the Cayman
3220-H.
3220-H.
autoboot { retry_count | off }
The
autoboot
retry_count
command (where
retry_count
is any
whole number) sets the number of times the Cayman 3220-H should
attempt to start an image and run it when powered up. If you enable
autoboot with the
attempt to start an image and run it when powered up. If you enable
autoboot with the
autoboot
retry_count
command, the