Mitsubishi 710 Manual De Usuario

- 6 -

On the back of the monitor two kinds of connections are
provided:  AC power connector for the AC input and DB9-
15P connector for video signal input.

One end of the AC power cord is connected to the AC
power connector on the back of the monitor.  The other end
is plugged into a properly grounded three-prong AC outlet.
The monitor’s auto-sensing power supply can automati-
cally detect 100-120V AC or 220-240V AC and 50 or 60Hz.

The attached signal cable provides a DB9-15P connector
for the VGA compatible analog RGB outputs on your
computer.

Figure 5 shows the signal cable connection to the Video
Graphics Adapter (VGA) port.

1. Power off, both the monitor and the computer.
2. Connect the one end of the signal cable to the DB9-

15P connector on the VGA controller card.

3. Power on the monitor, then the computer.
4. After using the system, power off the monitor, and the

computer.

Power Cord

Computer

VGA

Compatible

System

 DB9-15P

SIGNAL CABLE

Figure 5

The socket-outlet shall be installed near the equipment
and shall be easily accessible. During servicing, discon-
nect the plug from the socket-outlet.
Méme si le moniteur est mis hors tension il reste toujours
alimenté. La prise secteur devrait ainsi ètre facilement
accssible en cas d'urgence.

Figure 6 shows the signal cable and AD-A205
Adapter(option) to the video port in an Apple Macintosh.

1.

Power off, both the monitor and the computer.

2.

Set the DIP switches of the optional Macintosh Adapter
according to the setting chart.
(See 7.2 Optional Macintosh Adapter AD-A205 set-
tings)

3.

Connect the 15-pin (DB-15P) end of the AD-A205
Adapter to the straight 15-pin connector on the
Macintosh video port on the computer or on the video
board.

4.

Connect the sub-miniature 15-pin (DB9-15P) end of
the optional AD-A205 Adapter to the signal cable.

5.

Power on the monitor, then the Macintosh.

6.     After using the system, power off the monitor, and the

Macintosh.

•

For the Apple Macintosh Computers having a VGA
compatible port, steps 2 through 4 are not necessary.
Connect the end of the signal cable to the port directly.

Power Cord                SIGNAL CABLE

   Macintosh

Adapter

AD-A205

(Option)

Computer

Apple Macintosh

Computer

Figure 6

AD-A205

MITSUBISHI

ON

1 2 3 4 5 6

•

In case of Apple Macintosh G3 series, use "Control
Panel" of "Apple Menu" when selecting a resolution.
If select the resolution from "Control Bar", no screen
may be displayed  and the computer may freeze.