Quantum sdlt 220 Guía Del Usuario
APPENDIX A: Super DLTtape I Data Cartridge
SDLT 220 and SDLT 320 Product Manual
A-4
March 2004
81-85002-01
•
A dropped cartridge may have dislodged, loosened, or damaged internal
components. If you drop a cartridge, give it a thorough visual inspection, as
described in
components. If you drop a cartridge, give it a thorough visual inspection, as
described in
.
•
Never apply adhesive labels or “sticky” notes on the top, side, or bottom of
your Super DLTtape I data cartridge. Only use the slide-in type label provided
with each cartridge and slide it into the label slot on the cartridge.
your Super DLTtape I data cartridge. Only use the slide-in type label provided
with each cartridge and slide it into the label slot on the cartridge.
•
Do not use graphite pencils, water-soluble felt pens, or other debris-producing
writing instruments on your labels. Never erase a label — replace it.
writing instruments on your labels. Never erase a label — replace it.
•
Be certain you place the unused cartridge labels in the protective box so that
you do not inadvertently pick them up along with the cartridge during
subsequent usage. A static electricity charge on a cartridge may cause a label
to cling to the cartridge. A label that is accidentally inserted into the drive
along with a cartridge can prevent the hub reel and drive gear from meshing.
you do not inadvertently pick them up along with the cartridge during
subsequent usage. A static electricity charge on a cartridge may cause a label
to cling to the cartridge. A label that is accidentally inserted into the drive
along with a cartridge can prevent the hub reel and drive gear from meshing.
•
Follow all data cartridge handling instructions that accompany your cartridges
or tape drive.
or tape drive.
A.3 Data Cartridge Inspection Procedure
Ensure that your tape backup solution performs reliably by following the Visual
Mechanical Inspection (VMI) procedures described in this subsection. These steps
will help you identify any potential data cartridge problems, and will prevent
accidental loss of data or damage to your SDLT system.
Mechanical Inspection (VMI) procedures described in this subsection. These steps
will help you identify any potential data cartridge problems, and will prevent
accidental loss of data or damage to your SDLT system.
You should do an inspection:
•
As a general practice whenever you change or load a new data cartridge
•
If a data cartridge is dropped or subjected to some hard physical shock
•
If the SDLT drive becomes inoperable after loading a data cartridge
•
If you receive a shipment of data cartridges that show any sign of shipping
damage.
damage.
Follow these steps to visually inspect a Super DLTtape I data cartridge:
1.
Remove the data cartridge from its protective plastic case.
2.
Check for loose debris attached to the shell, and for other contamination (oily,
slimy, or sticky substances) that may have built up on the surface of the shell.
slimy, or sticky substances) that may have built up on the surface of the shell.