Quantum sdlt 220 Guía Del Usuario
CHAPTER 4: Installing Your Tape Drive
SDLT 220 and SDLT 320 Product Manual
4-6
March 2004
81-85002-01
4.3
Configuring and Installing an Internal
Tape Drive
Tape Drive
This section provides information for configuring and installing a tape drive into a
system. See
system. See
for information on
configuring and installing a tabletop tape drive.
Configuration for the SDLT system includes the following:
•
Setting the SCSI ID for the drive (default = SCSI ID 5).
•
Configuring the drive to provide TERMPWR.
•
Setting the configuration jumper (default = wide SCSI enabled).
If you want to change any of the settings, refer to the applicable subsection;
otherwise proceed directly to the tape drive’s installation procedures in
otherwise proceed directly to the tape drive’s installation procedures in
C
AUTION
: Before you begin, review the safety, ESD, and handling
precautions described at the beginning of this chapter to
avoid personal injury or damage to equipment.
avoid personal injury or damage to equipment.