Champion usn-72 Guía Del Usuario
8
2.4 Permanent Placement
Refer to Part 2.2, Disassembly and Part 2.3, Reassembly if your dishwasher requires transport through
ship hatches, otherwise proceed with the instructions listed below.
Perform the following steps to place the dishwasher in its permanent location.
1. Before moving the sections into position, inspect the location site to ensure the electrical,
plumbing, and ventilation services are provided in the correct locations. Compare the site
connections with the dishwasher to ensure they will match when the machine is set in its
permanent location.
CAUTION:
Check piping mounted underneath dishwasher before lifting, to avoid damaging the machine.
2. Lift the dishwasher and replace the adjustable legs with the flanged mounting feet provided.
3. Position dishwasher in its permanent location.
4. Level the dishwasher front to back and side to side by turning the adjustable feet.
3. Position dishwasher in its permanent location.
4. Level the dishwasher front to back and side to side by turning the adjustable feet.
Make sure the load and unload openings align with the table system height.
5. Position the external booster heater at the unload end of the dishwasher.
Check alignment of common plumbing connections between booster and dishwasher.
6. Install deck plates, and bolt dishwasher and booster to deck per standard procedures.
2.5 Connections between the dishwasher and booster
Refer to Figure 2.2 on the next page.
WARNING:
The installation of this unit must conform to local codes or, in the absence of local codes,
to the National Electrical Code and all National Codes governing plumbing, sanitation,
safety and good trade practices.
Connect the plumbing and electrical connections between the dishwasher and booster heater.
1. Connect the 1/2" condensate union from the dishwasher to the booster. (See No. 1, Fig. 2.2).
2. Connect the 3/4" steam union from the dishwasher to the booster. (See No. 2, Fig. 2.2).
3. Connect the 3/4" water line from the booster to the top of the dishwasher at the
2. Connect the 3/4" steam union from the dishwasher to the booster. (See No. 2, Fig. 2.2).
3. Connect the 3/4" water line from the booster to the top of the dishwasher at the
vacuum breaker. (See No. 3, Fig. 2.2).
4. Pull the electrical conduit and harness from the junction box located on the lower
rear corner of the dishwasher to the booster junction box located on the lower left rear leg
of the booster stand. (See No. 1, Fig. 2.2).
5. Match the harness wire numbers to the booster junction box wiring.
Part 2: INSTALLATION
!