GCC 12 Instruccion De Instalación

The software required to set up your Windows 95 computer is located on the Elite 12 Series
CD-ROM. For Windows 98 software installation instructions, go to page 34. 

You can install the Elite 12 Series software on your computer using Plug and Play. This will
work if you are installing the software on a computer which is connected to the printer
through the parallel port.

If the printer is not connected to the computer through the parallel port, go to the section
“Using Add Printer” immediately following the Plug and Play instructions.

Windows 95 uses a Wizard to help you install printer software. A Wizard is a series of dialog
boxes. In each dialog box you make configuration choices then click the Next button to
move to the next dialog box.

Part of the software you will need is contained on the Windows 95 CD-ROM or floppy disks.
If your computer was not supplied with the disk(s), follow the special instructions provided
when you reach this step of the installation process.

Part of the software you will need is on the Windows 95 CD-ROM. You must have this
disk ready, along with the Elite 12 Series CD-ROM, when you install the Elite 12 Series
software on your Windows 95 computer.

1. If the computer is running, shut it down.

2. With the computer powered off, attach the

printer cable to the computer and printer. Add

paper to the paper tray.

3. Turn on the printer. Verify that the printer LCD

panel reads “READY”. Start the computer.