GCC 12 Instruccion De Instalación

55

11. Press the Menu button and set the Broadcast Address. Press Enter to save the

settings.

12. Press the Menu button to set the Default Router. If you don’t have a default router

address enter a dummy address (i.e. 1.1.1.1) A Default Router Address MUST be
entered for the printer to communicate.  Press Enter to save the settings.

13. Press the Menu button to set the Syslog Host. Press Enter to save the settings.

14. Press the Menu button to set whether or not to print a header page at the beginning

of each print job. The default is Disabled. Press Enter to save the settings.

15. Press the On Line key to bring the printer back on line.

16. Switch the printer off, wait ten seconds, and then switch it on again.

17. If you want to check that your changes are now in effect, print a configuration page.

If the GCC Windows 95/98 printer software has not been installed on your computer, follow
the instructions in the previous section of this guide. Complete that installation installing
your printer as a Local Printer to the LPT Port.

If you have installed an earlier version of the LPR utility, you must deinstall it before
upgrading to a newer version. Use the deinstall.exe program in the GCC LPR folder on the
Elite 12 Series CD-ROM, then restart the computer.

When you install the program you will be asked if you want to create a port during the
installation process. Although you can create a port at a later date, we recommend that you
create a port during installation. If you want to create a port you must have the printer’s IP
address.

1.

Close all applications before installing the LPR
program using the setup.exe file. Click on
File, Run and enter the path for the install
(i.e. D:\lpr)