Enterasys brim-f6 Manual De Usuario
BRIM-F6 User’s Guide
Page 2-1
CHAPTER 2
INSTALLATION
This chapter contains instructions for unpacking the BRIM-F6, installing
FPIMs, and installing the BRIM-F6 into Cabletron devices that support
BRIM technology.
FPIMs, and installing the BRIM-F6 into Cabletron devices that support
BRIM technology.
Note
: The BRIM-F6 is not shipped with the FPIMs installed. You must
order the correct FDDI Port Interface Modules based upon your network
requirements.
requirements.
To install the BRIM and FPIMs, you need the following tools:
•
1 disposable wrist strap (provided with any BRIM, MIM or hub)
•
1 Phillips screwdriver.
Caution:
Observe all static precautions while handling modules.
2.1
Unpacking the BRIM and the FPIMs
Unpack the modules as follows:
1. Remove the shipping box material covering the module.
2. Carefully remove the module from the shipping box. Leave the module
in its static-shielding bag until you are ready to install.
3. After removing the module from its static-shielding bag, visually
inspect the device. If you notice any signs of damage, contact
Cabletron Systems Technical Support immediately.
Cabletron Systems Technical Support immediately.
BRIM-F Book Page 1 Monday, January 29, 1996 9:26 AM