Enterasys csx200 Guía Del Usuario

CSX200 Family User’s Guide 29

Attach the disposable grounding strap to your wrist (refer to the instructions outlined on the 
disposable grounding strap package).

Remove the CSX200 cover (refer to 

Remove the blank faceplate from the appropriate WAN slot.

Carefully insert the WPIM connector into the WPIM connector pins on the CSX200.

Press down firmly on the WPIM until the pins slide all the way into the connector. Ensure that 
the WPIM seats flush on the standoffs.

Secure the WPIM to the three standoffs using the screws.

Replace the CSX200 cover.

This section contains instructions on how to install the CSX200-COMP/ENCR into the CSX200 
chassis. To help eliminate any potential problems during or after installation, read and understand 
the following steps:

Attach one end of the antistatic wrist strap to your wrist and the other end to an approved 
electrical ground.

Unpack the CSX200-COMP/ENCR by carefully removing it from the shipping box and then 
from the protective plastic bag. Do not cut the bag as the device could be damaged. If there are 
any signs of damage, contact the Cabletron Systems Global Call Center. See the 

section of this document.

Power down the CSX200 before installing the CSX200-COMP/ENCR.

Remove the chassis cover of the CSX200 to install the CSX200-COMP/ENCR (refer to 

The CSX200-COMP/ENCR comes with a pre-attached metal cage. Do not remove 
this cage.