Enterasys ssr-glx19-02 Guía Del Usuario
CoreWatch User’s Manual
331
Chapter 16: Configuring Routing Policies on the SSR
Configuring IP Route Filters
The SSR uses IP route filters to match a certain set of routes by destination or by
destination and mask.
destination and mask.
Note:
A route will match the most specific filter that applies. Specifying more than one
filter with the same destination, mask, and modifiers will generate an error.
filter with the same destination, mask, and modifiers will generate an error.
To create IP route filters:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Routing Configuration object.
Routing Configuration object.
3.
Double-click the IP Routing Configuration object.
4.
Double-click the IP Unicast Routing object.
5.
Double-click the Routing Policy Configuration object.
6.
Double-click the Building Blocks object.
7.
Double-click the Filters object, and click the Configure New Filter object.
Configuration Expert opens the Route Filter wizard.
8.
Click Next.
A Filter Name panel similar to the following appears:
Figure 211. Filter Name panel