Marantz AV8003 Guía Del Usuario

ENGLISH

Creating copies using clone mode
All of the codes programmed to the RC101 remote 
controller can be copied to another RC101 using a 
few simple operations.
•  The remote controller can copy the entire 

contents.

•  When copying the entire contents, all programmed 

codes are copied.

The clone function can only be used for copying 
when using the same model (RC101) for both the 
transmitting and receiving remote controller.

 

  Place the receiver sensor of the receiving 

remote controller (top) so that it is facing the 
transmitter of the transmitting remote controller 
(top) at a distance of about 5 cm.

5 cm

 

 Press 

SET button and PLAY button of the 

transmitting remote controller until the SEND 
indicator blinks twice. 

 

  Then backlight fl ashes

 

  The transmitting side is now ready.

 

 Press 

SET button and STOP button of the 

receiving remote controller until the LEARN 
indicator blinks twice. 

 

  Then backlight fl ashes.

 

  The receiving side is now ready.

 

 Press 

the 

ENTER cursor button on the receiving 

remote controller. 

 

  Then back lights tune off.

 

 Press 

the 

ENTER cursor button on the 

transmitting remote controller. 

 

  Then backlights tune off.

 

  When copying is started, the SEND indicator of 

transmitting remote controller and the LEARN 
indicator of receiving remote controller start to 
blink.

 

  When the copying operation is completed, the 

back lights of transmitting remote controller and 
receiving remote controller are turned on.

 

  Do not touch either of the remote controls 

during the copying operation. Doing so could 
cause copying to fail.

 

  If the copying fails in the middle of the copying 

process, back light of receiving remote are 
flash. Press the SET button to return the 
normal mode. Check and perform steps 1 to 5 
again.

 

  Copying takes about 30 seconds to complete 

when the transmitting remote controller has 
been programmed to 100% capacity.

 

  Once copying is completed, press the SET 

button on both remote controls.

(When operating the unit by Multi Zone connected)

• Zone 

A 

(Default)

• Zone 

B

•  Zone C (The unit does not use this zone.)
•  Zone D (MAIN ZONE)

Change the control commands for each zone.

 

 Press 

SET button and ZONE button until the 

SEND indicator blinks twice.

 

  Then backlight fl ashes.

 

  Press each zone button(A/B button)

 

  When the procedure is successful, the SEND 

indicator will blink twice.

These buttons change a special code of each zone.

Tuner mode operation remote code (Refer to page 
75)

 

 Press 

SET button and POWER ON button until 

the SEND indicator blinks twice.

 

  Then backlight fl ashes.

 

  Press the 1-digit code by numeric keys. 

• Zone mode:  1 (Default)

•  Zone speaker mode:  2

In case of Zone D, only control for main zone is 
possible.

 

 Press 

ENTER button once to lock in the code.

 

  When the procedure is successful, the SEND 

indicator will blink twice.

These buttons change a special code of zone mode 
or zone speaker mode.

The control commands can be set independently in 
ZONE A/B.

AV8003N.indb   79

AV8003N.indb   79

08.4.28   10:49:43 AM

08.4.28   10:49:43 AM