Marantz NR1402 Guía Del Usuario
6
ENGliSh
DEutSch
FRANçAiS
itAliANo
ESpAñol
NEDERlANDS
SVENSKA
Connect
Carefully check the left (L) and right (R) channels and
+ (red) and – (black) polarities on the speakers being
connected to the thiit, and be sure to interconnect the
channels and polarities correctly.
Connecting the speaker cables
Peel off about 10 mm of sheathing from the tip of the speaker
cable, then either twist the core wire tightly or terminate it.
cable, then either twist the core wire tightly or terminate it.
NOTE
• Connect so that the speaker cable core wires do not protrude
from the speaker terminal. The protection circuit may be
activated if the core wires touch the rear panel or if the + and
– sides touch each other (
activated if the core wires touch the rear panel or if the + and
– sides touch each other (
v
m page 86 “Protection Circuit”).
• Never touch the speaker terminals while the power supply is
connected. Doing so could result in electric shock. (When the
Setup Wizard is running, follow the instructions in the Setup
Wizard screen for making connections.)
Setup Wizard is running, follow the instructions in the Setup
Wizard screen for making connections.)
• Use speakers with the speaker impedances shown below.
Speaker terminals
Speaker impedance
FRONT
6 – 8 Ω
CENTER
SURROUND
SURROUND
n Connecting the speakers
The speakers are connected in “2. Speaker Connection” of the Setup Wizard but if you did not use or cancelled the Setup Wizard, connect the speakers as shown below.
For details, see the included CD-ROM (Owner’s manual).
For details, see the included CD-ROM (Owner’s manual).
5.1-channel
FL
FR
C
SL
SR
SW