TiVo Series2 Guía De Instalación

S e t t i n g   t h e   D V R   S w i t c h

 Point the remote control at DVR #1. 

Use the number buttons on the remote control to enter a number “1.” Press the RIGHT 
arrow. On the screen, the “Remote Address” updates from “0” to “1.”

Press the TiVo button and go to TiVo Central. Side 1 now controls DVR #1 only. 
Continue to the next step and set up side 2 of the DVR SWITCH. If you don’t, side 2 
will still control both DVRs.

 Press the input, source, or TV/Video button you normally 

use, until your TV displays DVR #2. Then remove the cover from the plastic window 
of DVR #2 and cover the plastic window of DVR #1. Finally, go to the System 
Information screen of DVR #2, and press DOWN arrow until you see “Remote 
Address” displayed.

Move the DVR SWITCH to 2. Repeat 

steps 2 and 3, above.  Assign the number “2” to DVR #2, then press the TiVo button 
and go to TiVo Central.

Now when you set the DVR SWITCH to 1, it will only control DVR #1—and when 
you set it to 2, it will only control DVR #2.

1. Move the DVR SWITCH to 1.

2. Press and hold the PAUSE and TiVo buttons simultaneously for about three seconds, 

until the red light at the end of the remote control comes on and remains steady. 

3. Using the number buttons on the remote control, enter 0. The red light at the end of the 

remote control will flash to indicate that the DVR SWITCH (either 1 or 2) is reset.

4. To complete the reset, move the DVR SWITCH to 2 and repeat steps 2 and 3.

®