Sceptre s6900 Guía Del Usuario
Chapter 2: The BIOS Setup Program
29
The System Devices Menu
Selecting System Devices from the menu bar displays the System Devices
Menu. Please see Figure 2-2.
Menu. Please see Figure 2-2.
Main
Security
System Devices
Power
Exit
Boot
Item Specific Help
Enable the integrated
local bus IDE adapter
local bus IDE adapter
IDE Controller
[Both]
FDD Controller
[Enabled]
Internal touchpad
[Enabled]
Serial Port
[Auto]
Infrared Port
[Off]
Parallel Port
[Customized]
Mode:
[ECP]
Base I/O address:
[378]
Interrupt:
[IRQ 7]
DMA Channel:
[DMA 3]
Modem
Installed
PhoenixBIOS Setup Utility
F1
Help
Exit
Exit
ESC
Select Item
Select Menu
F5/F6
Enter
Enter
Change Values
Select
Select
Sub-Menu
F9
F10
F10
Setup Defaults
Save and Exit
Figure 2-2: The System Devices Menu
This menu allows you to configure the Notebook’s IDE and FDD controllers,
serial and parallel ports, as well as, IR (infrared) modes and the modem port.
Each field on this menu is covered below.
serial and parallel ports, as well as, IR (infrared) modes and the modem port.
Each field on this menu is covered below.
IDE Controller
This field allows you to configure the IDE Controller for the Notebook’s
installed hard drives. Available options for this field are:
installed hard drives. Available options for this field are:
•
= Disabled
•
= Primary
•
= Both
When Both is selected for this field, the IDE Controller will recognize both a
primary and a secondary IDE channel. Select Disabled if no hard drives are
installed. It is recommended that you use the default value for this field.
primary and a secondary IDE channel. Select Disabled if no hard drives are
installed. It is recommended that you use the default value for this field.
The default value for this field is: Both