Lenovo d20 4158 Manual De Hardware
6.
To install the new hard disk drive into the bracket, flex the bracket, and then
align pin 1, pin 2, pin 3, and pin 4 on the bracket with the holes in the
hard disk drive. Do not touch the circuit board 5 on the bottom of the hard
disk drive.
align pin 1, pin 2, pin 3, and pin 4 on the bracket with the holes in the
hard disk drive. Do not touch the circuit board 5 on the bottom of the hard
disk drive.
Note:
If you are installing a 2.5-inch hard disk drive into the bracket, flex the
bracket, and then align pin 1, pin 2, pin 3, and pin 4 on the
bracket with the holes in the hard disk drive adapter 5.
bracket, and then align pin 1, pin 2, pin 3, and pin 4 on the
bracket with the holes in the hard disk drive adapter 5.
7.
Install the hard disk drive and bracket into the drive bay.
8.
Using the signal cable that came with the new drive, connect one end of the
signal cable to the drive. Locate one of the extra five-wire power cables and
connect it to the drive.
signal cable to the drive. Locate one of the extra five-wire power cables and
connect it to the drive.
Note:
The signal cable will be different depending on whether you are
installing a SATA hard disk drive or a SAS hard disk drive.
installing a SATA hard disk drive or a SAS hard disk drive.
Figure 1. Installing a 3.5-inch hard disk drive into the bracket
Figure 2. Installing a 2.5-inch hard disk drive into the bracket
120
Hardware Maintenance Manual