U-Line BI-2115 Guia De Especificaciones

Full Overlay Panel Preparation for
Models 2175, 2115 and CLR2160

IMPORTANT

The full overlay door panel must not weigh more
than 20 lbs. The thickness of the door panel must be
3/4".

1. Cut door panel to proper size (Figure 1). Be sure to

note which model the door will be used on.

Figure 1

Rear View of Wood Panel for Right Hand Hinge

Shown.

Use Mirror Image for Left Hand Hinges.

2. Create a relief (Figure 2) for pivot plate by cutting

notch in top corner. Refer to the following figures for
exact specifications.

Figure 2

Relief Notch for Pivot Plate

Figure 3A

Top View of Door

3. Drill hole for upper door hinge (top of panel)

(Figure 3A).

0.177" diameter
(#16 drill) x 11/16" deep

4. Drill hole for lower door hinge (Figure 3B).

5/16" diameter x 1/4" deep

Figure 3B

Bottom View of Door

NOTE: It is important to ensure that all drilled holes are
drilled to the correct depth in order to avoid splits in the
wood when hardware is installed.

29-3/4"

MODEL 2175: 23-3/4"

MODEL 2115 and CLR2160: 14-3/4"

PIVOT PLATE RELIEF
SEE FIGURE 2

3/4"

31/32"

1/8"

15/32"

3/8"

Ø.177 (#16 DRILL X 11/16" DEEP)

3/8"

13/32"

Ø 5/16" X 1/4" DEEP
CHAMFER 1/32" X 45"

Printed in U.S.A.
P/N 30113 (Rev. 3/2006)

U-Line Corporation

P.O. Box 245040 • Milwaukee, WI 53224-9540

Phone 414.354.0300 • Fax 414.354.7905