Yamaha RX-Z11 Guía Del Usuario

Graphical user interface (GUI) menu

104

■ Parametric EQ (Parametric equalizer)

Use this feature to adjust the parametric equalizer of each speaker.

PEQ Data Copy (Parametric equalizer data copy)
Use this feature to copy the result data of the automatic setup to the
manual configuration area. You can select the parametric equalizer
type applied to the copied result data of the automatic setup. See
page 50 for the descriptions of each parametric equalizer type.

PEQ Select (Parametric equalizer type select)
Use this feature to select the parametric equalizer type that applied
to the results of the automatic setup. See page 50 for the
descriptions of each parametric equalizer type.

• When you carry out the automatic setup, this unit automatically set “PEQ

Select” to “Natural”.

• “Speaker Level” settings (see page 102) also changes corresponding to the

setting of “PEQ Select”.

• This unit does not change the configurations of “Manual” even if you

perform the automatic setup.

Manual parametric equalizer configuration of each
speaker
Use this feature to adjust the tonal quality of each speaker. You can
copy the results of the automatic setup for the base of the manual
configuration by using “PEQ Data Copy”. Set “PEQ Select” to
“Manual” in advanced.

Press 9k / n / l / h to select “Test Tone” or the
speaker you want to adjust.

Test Tone
Use this feature to select whether to turn on or off the test tone
output while you are adjusting the tonal quality of each
speaker.

Press 9h to access the settings window.

Press 9k / n / l / h to select “PARAM” and then
press 9

ENTER to select a parameter from “Band”

(band), “Freq.” (frequency) or “Q” (Q factor).

y
You can adjust “Gain” (gain) with any parameter.

Choice

Descriptions

Flat

→ Manual

Copies the result of the automatic setup that the “Flat”
type parametric equalizer is applied to.