ZyXEL NBG-318S Guía Del Usuario
Chapter 23 Troubleshooting
NBG-318S User’s Guide
212
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide.
2 Make sure you entered your ISP account information correctly in the wizard. These
fields are case-sensitive, so make sure [Caps Lock] is not on.
3 If you are trying to access the Internet wirelessly, make sure the wireless settings in the
wireless client are the same as the settings in the AP.
4 Disconnect all the cables from your device, and follow the directions in the Quick Start
Guide again.
5 Go to Maintenance > Sys OP Mode > General. Check your System Operation Mode
setting.
• Select Router (Ethernet WAN) if your network is configured to access the Internet
• Select Router (Ethernet WAN) if your network is configured to access the Internet
through an Ethernet connection to a DSL or cable modem.
• Select Router (HomePlug WAN) if your network is configured to access the Internet
through a HomePlug connection.
6 If the problem continues, contact your ISP.
V
I cannot access the Internet anymore. I had access to the Internet (with the
NBG-318S), but my Internet connection is not available anymore.
NBG-318S), but my Internet connection is not available anymore.
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See
the Quick Start Guide and
2 Reboot the NBG-318S.
3 If the problem continues, contact your ISP.
3 If the problem continues, contact your ISP.
V
The Internet connection is slow or intermittent.
1 There might be a lot of traffic on the network. Look at the LEDs, and check
. If the NBG-318S is sending or receiving a lot of information, try closing
some programs that use the Internet, especially peer-to-peer applications.
2 Check the signal strength. If the signal strength is low, try moving the NBG-318S closer
to the AP if possible, and look around to see if there are any devices that might be
interfering with the wireless network (for example, microwaves, other wireless
networks, and so on).
interfering with the wireless network (for example, microwaves, other wireless
networks, and so on).
3 Reboot the NBG-318S.
4 If the problem continues, contact the network administrator or vendor, or try one of the
4 If the problem continues, contact the network administrator or vendor, or try one of the
advanced suggestions.
Advanced Suggestions
• Check the settings for bandwidth management. If it is disabled, you might consider
activating it. If it is enabled, you might consider changing the allocations.
• Check the settings for QoS. If it is disabled, you might consider activating it. If it is
enabled, you might consider raising or lowering the priority for some applications.