ZyXEL 2WG Guía Del Usuario

 Chapter 19 Static Route Screens

ZyWALL 2WG User’s Guide

The following table describes the labels in this screen. 

Click the edit icon in the IP Static Route screen. The screen shown next appears. Use this 
screen to configure the required information for a static route.

Figure 252   ADVANCED > STATIC ROUTE > IP Static Route > Edit

The following table describes the labels in this screen. 

Table 119   ADVANCED > STATIC ROUTE > IP Static Route

#

This is the number of an individual static route.

Name

This is the name that describes or identifies this route. 

Active

This field shows whether this static route is active (Yes) or not (No).

Destination

This parameter specifies the IP network address of the final destination. Routing is 

always based on network number. 

Gateway

This is the IP address of the gateway. The gateway is a router or switch on the same 

network segment as the ZyWALL’s interface. The gateway helps forward packets to 

their destinations.

Modify

Click the edit icon to go to the screen where you can set up a static route on the 

ZyWALL.
Click the delete icon to remove a static route from the ZyWALL. A window displays 

asking you to confirm that you want to delete the route. 

Table 120   ADVANCED > STATIC ROUTE > IP Static Route > Edit

Route Name

Enter the name of the IP static route. Leave this field blank to delete this static route.

Active

This field allows you to activate/deactivate this static route.

Destination IP 

Address

This parameter specifies the IP network address of the final destination.  Routing is 

always based on network number. If you need to specify a route to a single host, 

use a subnet mask of 255.255.255.255 in the subnet mask field to force the network 

number to be identical to the host ID.

IP Subnet Mask  Enter the IP subnet mask here.