ZyXEL p-660h-61 Guía Del Usuario

Prestige 660H Series User’s Guide 

34-6 

 Firmware and Configuration File Maintenance 

Enter “open”, followed by a space and the IP address of your Prestige.   

Press [ENTER] when prompted for a username. 

Enter your password as requested (the default is “1234”). 

Enter “bin” to set transfer mode to binary. 

Find the “rom” file (on your computer) that you want to restore to your Prestige. 

Use “put” to transfer files from the Prestige to the computer, for example, “put config.rom rom-0” 

transfers the configuration file “config.rom” on your computer to the Prestige. See earlier in this 
chapter for more information on filename conventions. 

Enter “quit” to exit the ftp prompt. The Prestige will automatically restart after a successful restore 

process. 

Refer to section 34.2.5 to read about configurations that disallow TFTP and FTP over WAN. 

This section shows you how to upload firmware and configuration files.  You can upload 
configuration files by following the procedure in the previous Restore Configuration section or by 
following the instructions in Menu 24.7.2 – System Maintenance – Upload System Configuration 
File. 

 

FTP is the preferred method for uploading the firmware and configuration. To use this feature, your 
computer must have an FTP client.  

When you telnet into the Prestige, you will see the following screens for uploading firmware and the 
configuration file using FTP. 

ftp> put config.rom rom-0 
200 Port command okay 
150 Opening data connection for STOR rom-0 
226 File received OK 
221 Goodbye for writing flash 
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. 
ftp>quit