ZyXEL p-2802h-i1 Manual De Usuario

 Chapter 6 WAN Setup

P-2802H(W)(L)-I Series User’s Guide

The following table describes the labels in this screen.  

Table 20   Internet Access Setup

General

Mode

Select Routing (default) from the drop-down list box if your ISP give you one IP 

address only and you want multiple computers to share an Internet account. 

Select Bridge when your ISP provides you more than one IP address and you 

want the connected computers to get individual IP address from ISP’s DHCP 

server directly. If you select Bridge, you cannot use Firewall, QoS, DHCP server 

and NAT on the ZyXEL Device.

Note: If you set the first Ethernet port as a WAN interface, the 

ZyXEL Device is always in routing mode and this field will 
not be configurable.

Encapsulation

Select the method of encapsulation used by your ISP from the drop-down list 

box. This field is available only when you select Routing in the Mode field. 

Choices are Ethernet and PPPoE.

User Name

(PPPoE encapsulation only) Enter the user name exactly as your ISP assigned. 

If assigned a name in the form user@domain where domain identifies a service 

name, then enter both components exactly as given.

Password

(PPPoE encapsulation only) Enter the password associated with the user name 

above.

Service Name

(PPPoE only) Type the name of your PPPoE service here.

IP Address

This option is available if you select Routing in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is 

not fixed; the ISP assigns you a different one each time you connect to the 

Internet. 
Select Obtain an IP Address Automatically if you have a dynamic IP address; 

otherwise select Static IP Address and type your ISP assigned IP address in 

the IP Address field below. 

IP Address

Enter the IP address assigned by your ISP if you select Static IP Address.

Subnet Mask 

This field is avavilable when you select Ethernet in the Encapsulation field.
Enter a subnet mask in dotted decimal notation if you select Static IP Address.

Gateway IP 

address

This field is avavilable when you select Ethernet in the Encapsulation field.
Specify a gateway IP address (supplied by your ISP) if you select Static IP 

Address. 
If you set the first Ethernet port as a WAN port and connect the Ethernet port to 

a broadband modem or router, enter the broadband modem or router’s LAN IP 

address here.

DNS Server

First DNS 

Server

Second DNS 

Server

Third DNS 

Server

Select Obtained From ISP if your ISP dynamically assigns DNS server 

information (and the ZyXEL Device's WAN IP address) and you select Obtain 

an IP Address Automatically.
Select UserDefined if you have the IP address of a DNS server. Enter the DNS 

server's IP address in the field to the right. If you chose UserDefined, but leave 

the IP address set to 0.0.0.0, UserDefined changes to None after you click 

Apply. If you set a second choice to UserDefined, and enter the same IP 

address, the second UserDefined changes to None after you click Apply. 
Select None if you do not want to configure DNS servers. You must have 

another DNS server on your LAN, or else the computers must have their DNS 

server addresses manually configured. If you do not configure a DNS server, 

you must know the IP address of a computer in order to access it.