ZyXEL nbg-334w Guía Del Usuario

NBG334W User’s Guide

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual 
clients to obtain TCP/IP configuration at start-up from a server. You can configure the 
NBG334W as a DHCP server or disable it. When configured as a server, the NBG334W 
provides the TCP/IP configuration for the clients. If DHCP service is disabled, you must have 
another DHCP server on your LAN, or else the computer must be manually configured.

Click Network > DHCP Server. The following screen displays.

Figure 59   Network > DHCP Server > General   

The following table describes the labels in this screen.

Table 43   Network > DHCP Server > General 

Enable DHCP Server

DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) 

allows individual clients (computers) to obtain TCP/IP configuration at startup 

from a server. Leave the Enable DHCP Server check box selected unless 

your ISP instructs you to do otherwise. Clear it to disable the NBG334W 

acting as a DHCP server. When configured as a server, the NBG334W 

provides TCP/IP configuration for the clients. If not, DHCP service is disabled 

and you must have another DHCP server on your LAN, or else the computers 

must be manually configured. When set as a server, fill in the following four 

fields.

IP Pool Starting 

Address

This field specifies the first of the contiguous addresses in the IP address 

pool.

Pool Size

This field specifies the size, or count of the IP address pool.

Apply

Click Apply to save your changes back to the NBG334W.

Reset

Click Reset to begin configuring this screen afresh.