ZyXEL NBG-416N Guía Del Usuario

Chapter 20 Troubleshooting

NBG-416N User’s Guide

Press the RESET button for longer than 1 second to restart/reboot the NBG-416N.

Press the RESET button for longer than five seconds to set the NBG-416N back to 
its factory-default configurations.

If the NBG-416N restarts automatically, wait for the NBG-416N to finish 
restarting, and log in to the Web Configurator. The username is admin and 
password is 1234.

If the NBG-416N does not restart automatically, disconnect and reconnect the 
NBG-416N’s power. Then, follow the directions above again.

I cannot access the NBG-416N or ping any computer from the WLAN (wireless 
AP or router).

Make sure the wireless LAN is enabled on the NBG-416N.

Make sure the wireless adapter on the wireless station is working properly.

Make sure the wireless adapter installed on your computer is IEEE 802.11 
compatible and supports the same wireless standard as the NBG-416N.

Make sure your computer (with a wireless adapter installed) is within the 
transmission range of the NBG-416N.

Check that both the NBG-416N and your wireless station are using the same 
wireless and wireless security settings.

Make sure traffic between the WLAN and the LAN is not blocked by the firewall on 
the NBG-416N. 

Make sure you allow the NBG-416N to be remotely accessed through the WLAN 
interface. Check your remote management settings.

• See 

 for more information.

I can access the Web Configurator after I switched to AP mode.