Yukon 1x24 Guía Del Usuario

 

 
WARNINGS AND PRECAUTIONS 
Attention! If the kit is operated in cold weather  and brought into warm premises it is absolutely 
necessary to carry out the following: 
    - to warm the device, do not remove the device from the case this prevents the appearance of 
condensation in the electronic and optical elements; 
    - it can only be used again after 2-3 hours.  
Never direct the unit at a bright source of light. 
Don't unseal and repair the unit which has a guaranteed warranty, unless opened. 
Don't put the unit in water; don't leave it in the rain or direct sunlight. 
Avoid mechanical and consequential damages. 
 
MAINTENANCE 
Cleaning optical parts can only be done using special cleaner for multicoated lenses, with a soft 
cloth.  
Dust can be removed from the lenses with a soft brush. 
The body of the binoculars can be coated in a synthetical cleaner using a soft cloth. 
 
STORAGE 
Always store the Tracker binoculars and the Head Mount (in its case) in a dry well-ventilated and 
well-heated room away from heating/air conditioning vents. Remove the battery if the binoculars 
are to be stored longer than two months. 
 
TROUBLESHOOTING 
The scope will not turn on. 
Check that the battery is installed properly. Install the battery according to the marking. Check the 
battery contact to ensure it is clean and free of corrosion. Check that the contact spring is not 
squeezed (one can raise it).  
Check that the cover of the battery compartment has been installed correctly, probably, it has been 
screwed not till the end or skewed. Replace the battery, probably, it is empty.