Crown cdi 1000 Manual Suplementario

Crown International
1718 W. Mishawaka Rd.
Elkhart, IN 46517-9439
TEL:574-294-8200
FAX: 574-294-8FAX
www.crownaudio.com

8/07                                                             139648-3    

Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown ampli-
fi er—an unsurpassed industry standard. With this unprecedented No-Fault protection, your new 
Crown amplifi er is warranted to meet or exceed original specifi cations for the fi rst three years of 
ownership. During this time, if your amplifi er fails, or does not perform to original specifi cations, 
it will be repaired or replaced at our expense. About the only things not covered by this warranty 
are those losses normally covered by insurance and those caused by intentional abuse. And the 
coverage is transferable, should you sell your amplifi er.

See your authorized Crown dealer for full warranty disclosure and details. For customers outside 
of the USA, please contact your authorized Crown distributor for warranty information or call 
574-294-8200.

Signal Indicator: Green LED, one per chan-
nel, illuminates when a very low-level signal is 
present at input. 

–10 Indicator: Green LED fl ashes when output 
signal exceeds –10 dB below clip.

–20 Indicator: Green LED fl ashes when output 
signal level exceeds –20 dB below clip.

Ready Indicator: Green LED, one per chan-
nel, illuminates when the amplifi er is ready to 
produce audio.

Clip Indicator: Red LED, one per channel, turns 
on at the threshold of audible distortion.

Temp Indicator: Red LED, one per channel, 
illuminates under excessive temperature 
conditions. 

Power Indicator: Blue LED illuminates when 
the amplifi er has been turned on and has 
power. 

AC Line Connector: NEMA 5-15P (15A).

Input Connector: Two 3-pin removable 
Phoenix-type connectors each accept a 
balanced line-level input signal.

Output Connectors: 4-position barrier strip 
with connectors for dual louspeakers or bridge-
mono loudspeaker. Dual connectors work with 
2-8 ohm or 70V/100V loads. Bridge-mono con-
nectors work with 4-8 ohm or 140V loads.

HiQnet USB Connector: Type B, connects to a 
USB port on a PC.

CDi-Series amplifi ers are protected against 
shorted, open or mismatched loads; overloaded 
power supplies; excessive temperature; chain 
destruction phenomena; excessive output 
current, and input overload damage. They also 
protect loudspeakers from input/output DC, 
large or dangerous DC offsets and turn-on/
turn-off transients.

Non-touch cover
Locking level-control knobs.

Chassis: Steel.

Cooling: Proportional speed fan with front-to-
rear airfl ow.

Dimensions: EIA Standard 19-in. rack mount 
width (EIA RS-310-B), 3.5 in. (8.9 cm) high and 
12.25 in. (31.11 cm) deep behind mounting 
surface.

Net Weight:
19 lb (8.6 kg).

Shipping Weight:
22 lb (10.0 kg). 

Specifi cations subject to change without  prior notice. Latest 
information available at www.crownaudio.com.

Crown, Crown Audio and Macro-Tech are registered 
trademarks of Crown International. Other trademarks are the 
property of their respective owners. ©2007 Crown Audio

®

, 

Inc. Printed in U.S.A.