Crown cp660 Manual De Usuario
CP660 Power Amplifi er
Operation Manual
page 6
3 Setup
Figure 3.2 Airfl ow
Figure 3.1 Dimensions
3.3 Ensure Proper Cooling
When using an equipment rack, mount units
directly on top of each other. Close any open
spaces in rack with blank panels. DO NOT
block side or front air vents.
directly on top of each other. Close any open
spaces in rack with blank panels. DO NOT
block side or front air vents.
Figure 3.2 illustrates standard amplifier air-
flow.
flow.
3.1 Unpack Your Amplifi er
YOU WILL NEED (not supplied):
• Input
wiring
cables
• Output
wiring
cables
• Rack for mounting amplifi er (or a stable
surface for stacking)
WARNING: Before you start to set up
your amplifi er, make sure you read and
observe the Important Safety Instruc-
tions found at the beginning of this
manual.
your amplifi er, make sure you read and
observe the Important Safety Instruc-
tions found at the beginning of this
manual.
3.2 Install
Your Amplifi er
CAUTION: Before you begin, make sure
your amplifi er is disconnected from the
power source, with power switch in the
“off” position and all level controls
turned completely down (counterclock-
wise).
your amplifi er is disconnected from the
power source, with power switch in the
“off” position and all level controls
turned completely down (counterclock-
wise).
Use a standard 19-inch (48.3 cm) equipment
rack. See Figure 3.1 for amplifi er dimensions.
rack. See Figure 3.1 for amplifi er dimensions.
You may also stack amps without using a
cabinet.
cabinet.
NOTE: When transporting, amplifi ers should be
supported at both front and back.
supported at both front and back.