Crown m120 Manual De Usuario
page 9
M Series Power Amplifiers
Operation Manual
2.6.2 Bridge-Mono Mode
Typical input and output wiring is shown in
Figure 2.9.
Figure 2.9.
Set the Mode Switch to Bridge.
INPUTS: Use only the Channel-1 input connec-
tor.
tor.
NOTE: Crown provides a reference of wiring pin
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.
OUTPUTS: If you are using the 5-way binding
posts, connect the speaker across the red bind-
ing post of each channel. Do not use the black
binding posts when the amp is being operated in
Bridge-Mono mode.
posts, connect the speaker across the red bind-
ing post of each channel. Do not use the black
binding posts when the amp is being operated in
Bridge-Mono mode.
If you are using the Speakon
®
connectors, use
only the Channel 1 connector.
NOTE: The Channel 2 level control MUST
be turned down (full CCW) when operat-
ing the amplifier in Bridge-Mono mode.
be turned down (full CCW) when operat-
ing the amplifier in Bridge-Mono mode.
Figure 2.9
System Wiring, Bridge-Mono Mode
2 Setup