Crown ma-3600vz Guía Del Usuario
Operation Manual
Macro-Tech MA-3600VZ Power Amplifier
page 10
3.6.3 Parallel-Mono Mode
Typical input and output wiring is shown in
Figure 3.8.
Figure 3.8.
INPUTS: Connect input wiring to Channel 1.
Refer to Section 3, Figure 3.4 for input connector
pin assignments.
Refer to Section 3, Figure 3.4 for input connector
pin assignments.
OUTPUTS: Install a jumper wire between the
positive binding posts of both Channel 1 and
Channel 2 that is at least 14 gauge in size;
Connect positive (+) speaker lead to Channel 1
positive binding post of amp; connect negative
(–) speaker lead to Channel 2 negative binding
post of amp. Refer to Section 3.5 for output
connector pin assignments. Make sure the Mode
switch is set to the “Bridge” position when oper-
ating in Bridge-Mono mode.
positive binding posts of both Channel 1 and
Channel 2 that is at least 14 gauge in size;
Connect positive (+) speaker lead to Channel 1
positive binding post of amp; connect negative
(–) speaker lead to Channel 2 negative binding
post of amp. Refer to Section 3.5 for output
connector pin assignments. Make sure the Mode
switch is set to the “Bridge” position when oper-
ating in Bridge-Mono mode.
NOTE: Turn down (full CCW) the Channel
2 level control when operating in Paral-
lel-Mono mode, as the Channel 1 level
control works both channels.
2 level control when operating in Paral-
lel-Mono mode, as the Channel 1 level
control works both channels.
NOTE: Remove the jumper wire before
changing to any mode except Parallel-
Mono.
changing to any mode except Parallel-
Mono.
NOTE: Crown provides a reference of wiring pin
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.com.
assignments for commonly used connector
types in the Crown Amplifier Application Guide
available at www.crownaudio.com.
Figure 3.8 System Wiring, Parallel-Mono Mode
3 Setup