Crown xls 202 Guia De Especificaciones

Crown International

P.O. Box 1000

Elkhart, IN 46515-1000

TEL: 219-294-8200

FAX: 219-294-8FAX

www.crownaudio.com

08/01                                                            133616-1  

 

Crown offers a Three-Year, No-Fault, Fully Transferable Warranty for every new Crown ampli-

fier—an unsurpassed industry standard. With this unprecedented No-Fault protection, your new 

Crown amplifier is warranted to meet or exceed original specifications for the first three years of 

ownership. During this time, if your amplifier fails, or does not perform to original specifications, 

it will be repaired or replaced at our expense. About the only things not covered by this warranty 

are those losses normally covered by insurance and those caused by intentional abuse. And the 

coverage is transferable, should you sell your amplifier.
See your authorized Crown dealer for full warranty disclosure and details. For customers outside 

of the USA, please contact your authorized Crown distributor for warranty information or call 

219-294-8200.

Specifications subject to change without prior notice. Latest 

information available at www.crownaudio.com.
Crown is a registered trademark of Crown International. Other 

trademarks are the property of their respective owners. Printed 

in U.S.A.
© 2001 Crown Audio, Inc.

Input Connectors: One per channel; back-

panel three-pin female XLR input connectors 

are provided.
Input Impedance (nominally balanced, nomi-

nally unbalanced): 20 k ohms, 10 k ohms.
Output Connectors: One pair of back-panel, 

5-way binding posts per channel; accepts 

banana plugs, spade lugs or bare wire. (Euro-

pean models do not accept banana plugs.)
DC Output Offset (shorted input): ±10 millivolts.
Output Signal: Stereo, unbalanced, two-

channel.

XLS Series amplifiers provide extensive pro-

tection and diagnostic capabilities, including 

built-in anti-clip limiters, switchable high-pass 

filters, output current limiting, DC protection, 

fuses, and special thermal protection for the 

unit’s transformers.

Ventilation: Flow-through ventilation from 

front to back.
Cooling: Internal heat sinks with forced-air 

cooling for rapid, uniform heat dissipation. 

Air Volume Requirements (per minute per 

unit): 80.15 ft³ (2.27 m³).
Dimensions: EIA Standard 19-inch (48.3-cm) 

rack mount width (EIA RS-310-B), 5.25-inch 

(13.3-cm) height and 12.6-inch (32.0-cm) 

depth behind the mounting surface.

Net Weight: 30 lbs. (13.0 kg).
Shipping Weight: 37 lbs. (17 kg).