Brother HL-6050D Guía De Instalación Rápida

3

This printer follows EN55022 (CISPR Publication 22)/Class B.

Before you use this product, make sure that you use a double-shielded parallel interface cable with twisted-pair 
conductors and that it is marked “IEEE 1284 compliant”. The cable must not be more than 2.0 metres long.

This printer is a Class 1 laser product as defined in IEC 60825 specifications. The label shown below is attached 
in countries where it is needed.

This printer has a Class 3B laser diode which produces invisible laser radiation in the scanner unit. You should not 
open the scanner unit under any circumstances. 

Use of controls or adjustments or performance of procedures other than those specified herein may result in 
hazardous radiation exposure.

Maximum radiation power:

10 mW

Wave length:

760 - 810 nm

Laser class:

Class IIIb

To ensure safe operation the supplied three-pin plug must be inserted only into a standard three-pin power outlet 
that is properly grounded through the standard electrical wiring. 

Extension cords used with this printer must be three-pin plug type and correctly wired to provide proper grounding. 
Incorrectly wired extension cords may cause personal injury and equipment damage. 

The fact that the equipment operates satisfactorily does not imply that the power is grounded and that the 
installation is completely safe. For your safety, if in any doubt about the effective grounding of the power, call a 
qualified electrician. 

You must install this printer near a power outlet that is easily accessible. In case of an emergency, you must 
disconnect the power cord from the power outlet to shut off the power completely.

Connect this product to a LAN connection that is not subjected to over voltages.