Jet ghd-20 Manual De Usuario

 

10 

Referring to Figure 7: 

1.  With the aid of a second person, carefully lift 

the  head onto the column top and slide it 
down into position 

 

2.  Rotate head assembly until sides of the pulley 

cover are parallel with the sides of the base. 

3.  Tighten two setscrews (A) with a 5mm hex 

wrench (provided) until they are snug. 

4. Install three downfeed handles (B) into the 

downfeed hub (C). 

 

 

 

Referring to Figure 8: 

1.  Raise table to approximately seven inches 

below spindle assembly, and lock the table in 
place. 

2.  Place a piece of scrap wood (D) on the table. 

3.  Thoroughly clean the internal and external 

taper of the arbor (A), and chuck (B) and 
spindle (C). 

Important:  These three pieces must be free of 
any rust protection, or lubricant.  If they are not 
clean, the arbor and chuck will fail to seat in the 
spindle. 

4.  Place arbor (A) into the chuck (B). 

5.  Twist the chuck to retract the chuck jaws if 

they are exposed. 

6.  Place arbor and chuck assembly into the 

spindle (C). 

7.  Turn the arbor and chuck assembly until the 

tang on the arbor engages the slot at the end 
of the spindle. 

8.  Lower the down feed handle (E) so that the 

chuck meets the scrap wood. Place 
downward pressure on the feed handle to 
seat the arbor and chuck into the spindle.