Jet jwl-1442vsk pro woodworking lathe Guía Del Usuario
10
Controls and Features
E. Headstock Lock Handle: (E, Fig. 4)
Locks the head in position. Unlock the handle
to position the head in any location along the
lathe bed. Tighten handle when properly
positioned.
to position the head in any location along the
lathe bed. Tighten handle when properly
positioned.
F. Headstock Indexing Pin: (F, Fig. 4
Turn the knurled knob counter-clockwise to
unlock the plunger. Pull the knob out to release
the headstock. Unlock the headstock-locking
handle and rotate the headstock. Turn knurled
knob clockwise until it stops to lock plunger.
unlock the plunger. Pull the knob out to release
the headstock. Unlock the headstock-locking
handle and rotate the headstock. Turn knurled
knob clockwise until it stops to lock plunger.
G. Headstock Spindle Lock: (G, Fig. 5)
Push in pin to keep the spindle from turning.
Never press the headstock
spindle lock while the spindle is turning!
H. Headstock On/Off Switch: (H, Fig.5)
Flip the switch up to turn “ON” the lathe. Flip
the switch down to turn the lathe “OFF”.
the switch down to turn the lathe “OFF”.
I.
Headstock On/Off Switch Key: (I, Fig. 5)
Remove key when in the “OFF” position. The
switch will not work until key is reinstalled.
Remove key when in the “OFF” position. The
switch will not work until key is reinstalled.
J. Headstock Speed Selector: (J, Fig. 5)
Place handle directly above the desired RPM
speed. Pull handle out and move to the desired
speed, see Figure 6.
speed. Pull handle out and move to the desired
speed, see Figure 6.
Only change speeds while the
spindle is turning!
Figure 4
Figure 5
Diameter
of Work
Roughing
RPM
General
Cutting
RPM
Finishing
RPM
Under 2"
1500 3000 3000
2 to 4"
600 1500 2300
4 to 6"
450 1100 1500
6 to 8"
450 600 1100
8 to 10"
450 600 850
10 to 12"
450 600 850
12 to 14"
450 450 600
Figure 6