Jet 350125 jmd-15 - jmd-15 milling Guía Del Usuario
6
Contents of the Shipping Container
1 Mill/Drill Machine
Accessory Package:
1
1/2” Drill Chuck w/ Chuck Key
1 Adjustable
Carbide
Facemill
1 Facemill
Arbor
1
Bolts, Nuts, and Washers to
Attach
Vise
to
Table
1
2-1/2” Angle Vise (JMD-15)
1
3” Angle Vise (JMD-18/18PFN)
3
Handle Rods (JMD-15/18)
3
Rubber Knobs (JMD-15/18)
2
Rubber Knobs (JMD-18PFN)
1
3/8”x1” Hex Socket Cap Screw
1
3/8”
Washer
1
Crank Body (Installed)
1
Crank
Handle
1
Spindle
Guard
Assembly
1
3mm
Hex
Wrench
1
4mm
Hex
Wrench
1
5mm
Hex
Wrench
1
23mm
Wrench
(JMD-18/18PFN)
3
Hand Wheels w/ Handles
1
Can Touch-Up Paint
1
Owner’s
Manual
1
Warranty
Card
1
Lifting
Hook
(Installed)
Unpacking and Clean-up
1. Finish removing the crate from the mill/drill.
Unbolt the machine from the crate bottom.
Report shipping damage, if any, to your
distributor.
Report shipping damage, if any, to your
distributor.
2. Clean all rust protected surfaces using a
mild commercial solvent, kerosene or diesel
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE
fuel. Do not use paint thinner, gasoline, or
lacquer thinner. These will damage painted
surfaces. Cover all cleaned surfaces with a
light film of Mobil DTE
® Oil Heavy Medium.
3. Open the belt cover and thread the lifting
hook into the head.
4. Carefully lift the mill/drill with properly rated
equipment to a sturdy stand or work bench.
5. Remove the lifting hook.
Tools Needed for Assembly
8” Adjustable Wrench or 1/4” to 1-1/4”
Combination Wrench Set
(JMD-18 shown with optional CS-18 stand)