Maytag medb200 Manual De Usuario

■

Is the lint screen clogged with lint?  

Lint screen should be cleaned before each load.

WARNING

■

restricting air movement?  

Run the dryer for 5-10 minutes. Hold your hand under the 

outside exhaust hood to check air movement. If you do not feel 
air movement, clean exhaust system of lint or replace exhaust 

vent with heavy metal or flexible metal vent. See the Installation 

Instructions.

■

Are fabric softener sheets blocking the grille?  
Use only one fabric softener sheet, and use it only once.

■

Is the exhaust vent the correct length?  

Check that the exhaust vent is not too long or has too many 

turns. Long venting will increase drying times. See the 
Installation Instructions. 

■

Is the exhaust vent diameter the correct size?  

Use 4" (102 mm) diameter vent material.

■

(7ºC)?  

Proper operation of dryer cycles requires temperatures above 
45ºF (7ºC).

■

Is the dryer located in a closet?  

Closet doors must have ventilation openings at the top and 

bottom of the door. The rear of the dryer requires 5" (127 mm) of 

airspace, and the sides and front of the dryer require a minimum 

of 1" (25 mm). See the Installation Instructions.

■

Has the Air Fluff modifier been selected?  

Select the right temperature for the types of garments being 

dried. See “Additional Features.”

■

Is the load too large and heavy to dry quickly?  

Separate the load to tumble freely.

■

Are clothes coming out of the Rapid Refresh Small Load cycle 
with damp or wet spots? 

Under certain environmental or installation conditions, you may 

experience underdrying. Select the CUSTOM REFRESH cycle 

(20 min. default time), which can be customized by selecting the 

temperature by pressing TEMP LEVEL and/or cycle time by 
pressing the TIME ADJUST 

+ (plus) or – (minus)

.

WARNING

■

Is the automatic cycle ending early?  
The load may not be contacting the sensor strips. Level the dryer.

Change the dryness level setting on Sensor Cycles. Increasing or 

decreasing the dryness level will change the amount of drying 

time in a cycle.

■

Is the lint screen clogged? 

Clean lint screen. Check for air movement.

■

Was dryer fabric softener properly used?  
Add dryer fabric softener sheets at the beginning of the cycle. 

Fabric softener sheets added to a partially dried load can stain 

your garments.

Drum stains are caused by dyes in clothing (usually blue jeans). 
This will not transfer to other clothing. 

■

Was the load removed from dryer at the end of the cycle? 

For Steam Dryers select Custom Refresh cycle to tumble the load 

with water and heat to help smooth out wrinkles from a load left 

in the dryer. 

■

Was the dryer overloaded? 

Dry smaller loads that can tumble freely. Smaller loads yield best 

results with the Rapid Refresh Small Load cycle. Results may also 

vary depending on fabric type. This cycle is best for reducing 

wrinkles and odors from loads consisting of wrinkle-free cotton, 

cotton polyester blends, common knits, and synthetics. 

■

Loads are still wrinkled following Steam cycles? 

Make sure water is connected to the dryer. Check that water inlet 

hose is connected to both the faucet and dryer’s water inlet 
valve. Check that the water supply is turned on. These cycles are 

best for smoothing out wrinkles and reducing odors from loads 

consisting of wrinkle-free cotton, cotton polyester blends, 

common knits, and synthetic garments.

NOTE: Refer to garment care label instructions. Dry clean only 

garments are not recommended.