Runco VX-6000D Guía Del Usuario
64
Runco VX-6000d Installation/Operation Manual
PRE
L
IMINAR
Y
Remote Control: The Remote Control menu shows you the primary and secondary
infrared (IR) codes to which the VX-6000d will respond. By default, both are set to 17. You
can change these codes if either:
infrared (IR) codes to which the VX-6000d will respond. By default, both are set to 17. You
can change these codes if either:
• Another device in the theater (a DVD player, for example) is responding to commands
from the standard DHD remote control (Figure 2-5) in ways that are unpredictable or
undesirable.
undesirable.
• You have multiple VX-6000d projectors and want to control them independently, as
opposed to broadcasting commands from a single remote to all of them. In this
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
projector.
scenario, you can use multiple remotes programmed to use different IR codes. Or, you
can use a single remote and change the IR code as needed to address a specific
projector.
When you change a remote code on the VX-6000d, you must re-program the standard
DHD remote control to send that same code. To do this:
DHD remote control to send that same code. To do this:
1.
Using a straightened paper clip or similar object,
press and hold the CODE button on the remote
control for approximately three seconds, or until
the LED on the remote lights solid red.
press and hold the CODE button on the remote
control for approximately three seconds, or until
the LED on the remote lights solid red.
– OR –
If your remote control unit does not have a CODE
button, press and hold the LIGHT button on the
remote control for approximately three seconds,
or until the LED on the remote lights solid red.
2.
Enter a new two-digit code between 00 and 31
inclusive. Include a leading zero for single-digit codes; for example, enter 9 as “09.”
inclusive. Include a leading zero for single-digit codes; for example, enter 9 as “09.”
3.
The LED turns off to confirm the code change. If you enter an invalid code, the LED
flashes for three or four seconds. Try again, entering a valid code.
flashes for three or four seconds. Try again, entering a valid code.
Analog Out Mode: Select Analog Out Mode from the Service menu to change the output
sync polarity from the DHD Controller. The choices are RGB-- (separate sync with
negative polarity), RGB++ (separate sync with positive polarity) or RGBS (composite
sync).
sync polarity from the DHD Controller. The choices are RGB-- (separate sync with
negative polarity), RGB++ (separate sync with positive polarity) or RGBS (composite
sync).
Use the DHD Controller front-panel keypad to change the projector
IR code. Then, change the code sent by the remote to match as
described below.
IR code. Then, change the code sent by the remote to match as
described below.
Do not change the “Type” setting in this menu.
Note
EXIT
RETURN