Garmin navtalk Manual De Propietario
103
Section 4
Appendix C
Section 6
The unit uses “pop-up” messages to alert you to unit operat-
ing characteristics. Press the ENTER or any other keypad key
to acknowledge and return to the page you were viewing.
ing characteristics. Press the ENTER or any other keypad key
to acknowledge and return to the page you were viewing.
Address Buffer Full - Try Entering a City or Zip Code
Appointment Memory Full - Delete old data to allow space
for new data.
for new data.
Approaching Turn - You are less than one minute away from
a turn in route.
a turn in route.
Arriving at Destination - You have reached your destination.
Auto-Redial Timer Not Ready - Wait for the timer to reset.
Basemap Failed - The base map has failed. Return unit to
GARMIN for service.
GARMIN for service.
Batteries Low - The batteries in your unit are low. Recharge
battery.
battery.
Batteries Too Low TX Disabled - The battery in your unit is
low and no longer capable of supporting unit phone operation.
Recharge battery.
low and no longer capable of supporting unit phone operation.
Recharge battery.
Blackjack - You have reached 21 points.
Blacklist Full - The list of blacklisted numbers is full. Turn the
unit Off then On to reset the list.
unit Off then On to reset the list.
Bookmark Memory Full - Delete old data to allow space for
new data.
new data.
Call Barred - An incoming call has been barred.
Call Barring ON - Acknowledgement that at least one Call
Barring feature is now active.
Barring feature is now active.
Call Cost Not Available - Contact your service provider to set
up this feature.
up this feature.
Call Diverted - The incoming call has been diverted.
Call Diverted, ON - Acknowledgement that a Call Divert
feature is currently active.
feature is currently active.
Call Failed - The outgoing call did not connect.
Call Service Activation OK - Confirmation that a Call Service
is now active.
is now active.
Call Service Active - When checking the status of a Call
Service, this message reports “Active”.
Service, this message reports “Active”.
Call Service Action Aborted - A Call Service action has been
aborted from the “Working” page.
aborted from the “Working” page.
Call Service Action Failed - The initiated action has failed
because you have not subscribed to that service or there are
network communication problems. If the service is active, try
again later.
because you have not subscribed to that service or there are
network communication problems. If the service is active, try
again later.
Call Service Action OK - (USSD), Unstructured Supplemen-
tary Service Data action has been accepted. See your service
provider for details.
tary Service Data action has been accepted. See your service
provider for details.
Messages
NvTlkGSMManual copy.indd 103
12/2/2002, 8:43:43 AM