Planar LC12 Guia De Especificaciones
Title: Engineering Specification: 12.1-inch AMLCD Monitor
Page 10 of 27
Document Number: 023-0284-00
Revision: A
4.0
VIDEO SIGNAL INPUT REQUIREMENTS
4.1 Video Input Lines
The Video Signal Connector consists of fifteen (15) positions wired numerically and supplied attached
to the Monitor as a chassis mounted connector per definitions listed in Table 2. The "NC" positions of
this connector are not used for any purpose.
to the Monitor as a chassis mounted connector per definitions listed in Table 2. The "NC" positions of
this connector are not used for any purpose.
Pin Number
Signal Name
1
Red Video
2
Green Video
3
Blue Video
4
Monitor Sense Line 3
(connected to Pin 10)
5
NC
6
Red video return
7
Green video return
8
Blue video return
9
NC
10
Signal Ground Reference
11
Monitor Sense Line 1
(connected to Pin 10)
12
Monitor Sense Line 2 (NC)
13
Horizontal Sync Input
14
Vertical Sync Input
15
NC
Table 2. Video Signal Connector – Pin Number Assignments
The Video Signal Connector that connects to the customer’s equipment is a female 15-pin connector
in a high density 9-pin D-Shell housing. Pin number assignments are defined in Table 2, and physical
layout as seen by the interface cable from user logic is shown in Table 4.
in a high density 9-pin D-Shell housing. Pin number assignments are defined in Table 2, and physical
layout as seen by the interface cable from user logic is shown in Table 4.
Figure 4. Video Signal Connector Illustration