Sonance cabinet lcr Instruccion De Instalación

S O N A N C E   S Y M P H O N Y

®

  C A B I N E T   L C R

Thank you for purchasing the Sonance Symphony

® 

Cabinet LCR. When

properly installed, this product will provide you with years of

entertainment pleasure.
To obtain the full potential of the Symphony Cabinet LCR, please read

all instructions before starting the installation. If you do not have the

necessary skills to install this product yourself, contact your authorized

Sonance dealer for installation options.

Each Symphony Cabinet LCR includes the following items:
(1) Symphony Cabinet LCR
(1) Grille
(4) Rubber feet

PN. 33-2919

REV. 03-2003

The Symphony Cabinet LCR should be located from 24" to 60" from

the floor whether the speaker is situated vertically or horizontally. The

ideal height would be to have the tweeters at ear level when you are

seated.

The left and right speakers should be separated approximately 72" to

120" apart center to center.

The listening position should be from 84" to 168" away from the three

front speakers.

After you have your three front speakers located use the calibration

signal in your surround sound receiver to set the levels of all the

speakers in your home theater. A sound pressure level meter is

strongly recommended to accurately set these levels. Refer to the

manual of your receiver for the steps necessary to perform this

calibration.

Step 3

Install the four self adhesive rubber feet on the bottom the Symphony

Cabinet LCR.

If you are going to place the Symphony Cabinet LCR vertically in your

installation locate the four feet as shown in figure A below. The feet

should be placed approximately 1" in from the corners of the cabinet.

If you are going to place the Symphony Cabinet LCR horizontally in

your installation locate the four feet as shown in figure B below. The

feet should be placed approximately 1" in from the corners of the

cabinet.

Step 1

Run the appropriate gauge wire from your amplifier to the Symphony

Cabinet LCR location. See the wire gauge chart on the back of this

manual for suggested wire length versus wire gauge.

Attach the wire from your amplifier to the terminals on the back of the

speaker, see figure C. Double check the polarity of the speaker wires,

amplifier + to  speaker + and amplifier - to speaker -. Proper polarity

is critical in home theater installations.

Step 2

Located on the terminal cup of the Symphony Cabinet LCR are two

toggle switches.

The toggle switch on the left side of the terminal cup is a tweeter level

control. Normally this control should be left in the "flat" position. The

flat position will produce excellent sound in most rooms. If you find the

sound of the Symphony Cabinet LCR too bright in your room set the

level control to the "- 3 dB" setting. If the sound in your room is too

dull the control should be set to the "+3 dB" setting.

The toggle switch on the right side of the terminal cup is a woofer

boundary compensation switch. If you locate the Symphony Cabinet

LCR on top of a television or in a book case the low frequency output

from the woofers will increase. This bass boost can increase the output

as much as 6 dB will normally occur from approximately 200 Hz down

to 65 Hz. Flip the boundary compensation switch to the "On" position

to reduce the low frequency output.

Step 4

24

"  to  60"

72"  to  120"

24

"  to  60"