VIZIO E422VA Guía Del Usuario

VIZIO E422VA User Manual 

Version 10/29/2010 

19 

 

www.VIZIO.com 

Set up the Internet connection using the initial Setup App or the Network Menu in the HDTV Settings App. 
Your HDTV has 802.11n single-band wireless, so you can connect your TV to the Internet through your 
wireless home network. Or you can also connect to the Internet by plugging in an Ethernet cable from 
your Internet connection into the Ethernet port on your HDTV. A wired connection may provide a more 
consistent connection depending on the conditions in your home environment. See Network Menu on 
page 42, for detailed information on setting up your Internet connection. 

Select the input source for your HDTV by pressing INPUT on the remote 
control or the side of your TV.  Pressing this button will cycle you through 
the following options: TV, AV, Comp, HDMI-1, HDMI-2, HDMI-3, HDMI-4, 
and RGB.  
Turn on your device and you will see a picture on your HDTV. If there is 
no picture, make sure you have selected the correct input on your HDTV.  

 

If the selected device is RF connected, your HDTV must be in TV 

mode and on either channel 3 or channel 4 matching the channel which 
has been selected on the back of the VCR, Cable Box, External TV Tuner 
or Satellite Receiver. Refer to Owner or User’s Manual of such equipment 
for details. 
 

Before you start watching TV, make sure that any Cable, Satellite or off-air antenna connections are 
secure. Also, verify that the power cord is plugged into a correctly grounded electrical outlet or surge 
protector. 
 

1.  Press the power button on the remote control. The small window on the bottom right handside of 

the front bezel will light up white   

2.  Select the input to which your device is connected that provides TV programming (e.g. TV, HDMI, 

COMP). 

 

 You should be able to see a picture.  If you do not, make sure that all of your HDTV connections 

are secure and you have selected the correct video input source. Each press of INPUT on the remote 
control will cycle through the available inputs. Press the button until the input associated with the device 
you want to view is shown. 
 

3.  When using the TV input, press the channel buttons on the remote control to change the channel. 

The channel buttons will not work if you are watching a program using HDMI, Component, or AV 
inputs. 

 If your HDTV is in TV mode, pressing CH+ and CH- will not work until a channel scan has been run. 

See Auto Channel Search on page 44. 
 

  You can use your HDTV Component input to accept A/V signal (Composite) from a source