JVC GZ-MC200 Manual De Instrucciónes

MasterPage: Body_Left

Set the power switch to 

 while pressing down the 

lock button located on the switch.

Press MODE to select 

.

● The camera is programmed to record still images on the 

medium in the SD slot by the factory preset. To switch the 
recording medium, see pages 26 and 27.

● To change the image size and picture quality, see pages 26 

and 29.

Press the recording start/stop button. The still image is 

recorded.

● To check how the image looks before recording, press the 

recording start/stop button halfway and hold. The 

 

indicator appears and stops blinking when the captured 
image is focused. To cancel the recording, release the 
recording start/stop button. To record it on the recording 
medium, press the recording start/stop button fully.

● If shooting is not performed for approx. 5 minutes when 

using the battery pack, the camera’s power shuts off 
automatically. To perform shooting again, set the power 
switch to OFF, then to 

. When using AC adapter, the 

camera enters the power save mode. To cancel the power 
save mode, perform any operation such as zooming.

● To turn the shutter sound off, see page 26.

● For approximate number of storable images, see page 42.

Keeping the recording start/stop button pressed in step 

3 

provides an effect similar to serial photography. (Interval 
between still images: approx. 0.3 seconds)
To use this function, set [CONTINUOUS SHOOTING] to 
[ON]. (

墌 pg. 26, 29)

● Continuous shooting may not work well depending on 

the recording medium.

If you press 

 during recording mode, the file recorded 

most recently will be deleted.

● However, if the recording mode (video, still image or voice) 

is switched or the power is turned off and on again after 
recording, you cannot delete the file.

GZ-MC200US.book  Page 22  Tuesday, September 7, 2004  9:56 PM