GE ZISS360NRSS Guía Del Usuario

NOTE: Before replacing the bulbs, review 
the light bulb information and WARNING.

1. Set the Master Light switch to the OFF position

(see Using the Master Light switch) and allow
the lamps to cool.

2. If the Water Filter Cartridge is installed,

remove it and replace with the filter 
bypass plug.

3. Holding the light shield with one hand, rotate

the support tabs until they clear the front of
the light shield. Then push back on the light
shield, lower the shield at the front and 
take out.

4. Remove the 4 screws securing the light

housing to the ceiling. There are two screws 
at the front and two at the back.

5. Lower the light housing at the front, then 

pull it toward you so the tabs at the back 
of the light housing come out of the slots 
on the back wall. The lamp assemblies will
release from the holders.

6. Turn the lamp

protector to
access the bulb.

NOTE: Always follow bulb manufacturer’s
directions for handling and replacing bulbs.

7. Remove the bulb by holding the base and

pulling straight out. Replace with a new bulb
and replace the lamp protector.

Lamp protectors 

must be replaced or the heat from the bulb
could damage the refrigerator.

Vous devez remettre en place les écrans
protecteurs des ampoules pour ne pas
endommager votre réfrigérateur avec 
la chaleur produite par les ampoules.

8. Holding up the light housing, place each

lamp assembly in its holder. Feed the
attached wires through the slots and 
tuck the wires outside the side of 
the light housing.

9. Insert the tabs on the back of the light

housing in the slots on the back wall. 
Raise the light housing into position 
and secure with the four screws.

10. Replace the light shield and rotate 

the support tabs back out so they support
the front of the shield.

11. Remove the filter bypass plug and replace

with the Water Filter Cartridge. Reset the
Master Light switch to the ON position.

22

Care and Cleaning

Upper light
shield

Screws

Screws

Slots

Light housing

Support tabs