GE d Guía Del Usuario
4
Chapter 1
Connections and Setup
Things to consider before you connect
Protect components from overheating
•
Don’t block ventilation holes on any of the components. Arrange the components so that air
can circulate freely.
can circulate freely.
•
Don’t stack components.
•
If you place components in a stand, make sure you allow adequate ventilation.
•
If you connect an audio receiver or amplifier, place it on the top shelf.
Position cables properly to avoid audio interference
•
Insert each cable firmly into the designated jack.
•
If you place components above the TV, route all cables down the side of the back of the TV
instead of straight down the middle of the back of the TV.
instead of straight down the middle of the back of the TV.
•
If your antenna uses 300-ohm twin lead cables, do not coil the cables. Also, keep the twin lead
cables away from audio/video cables.
cables away from audio/video cables.
Note: While your disc player is compatible with the largest number of discs possible, it cannot be guaranteed
that you will be able to play discs which might not be compatible with audio CD, VCD and SVCD standards.
In the case of writable and rewritable discs, compatibility with this player depends on the DVD writer, the
write software and the disc used.
that you will be able to play discs which might not be compatible with audio CD, VCD and SVCD standards.
In the case of writable and rewritable discs, compatibility with this player depends on the DVD writer, the
write software and the disc used.
Install Batteries in the Remote
1.
Remove the battery compartment cover.
2.
Insert the batteries (provided), by matching the diagram in the battery compartment to make
sure + and – are in the proper position.
sure + and – are in the proper position.
3.
Put the battery cover back in place.
Important Battery Information
•
If you’re not going to use the remote for a month or more, be sure to remove the batteries
because they can leak and cause damage.
•
Dispose of batteries in the proper manner, according to federal, state, and local regulations.
•
Any battery may leak electrolyte if mixed with a different battery type, if inserted incorrectly, if all
batteries are not replaced at the same time, if disposed of in fire, or if an attempt is made to
charge a battery not intended to be recharged.
•
Discard leaky batteries immediately. Leaking batteries can cause skin burns or other personal injury.
1
2
3