Brunton multi-navigator Manual De Propietario

1.2 -- Battery Insertion

1. Remove battery cover by turning the retaining screw

counter clockwise, and insert two AA batteries, as shown.

2. Replace battery cover.

Do not over tighten the retaining screw.

1.3 -- Power ON

1. Press and hold the ON button

An initialization procedure will begin by

showing version number, temperature and

battery status. The GPS receiver will then begin

searching for satellites to establish the current position.

1.4 -- Compass Calibration

For the highest possible electronic compass accuracy, calibrate the TrueMagnetic

compass each time batteries are installed.

To calibrate:

1. Press COMPASS button.

2. Press SET button to enter programming menu.
3. Press UP button twice, or until display shows DEVIATE COMPASS.
4. Center the bubble inside the circle of the green bubble level and press YES button.

(YES button is located just above the YES in the display).

5. When AUTODEV ROTATE SLOWLY text appears, rotate the unit 1

times in a span

of approximately 10 seconds.

6. When calibration is complete, the display will show SUCCESSFUL.

If it shows FAILED, repeat steps 1-6 above.

2 -- StraightHome

The StraightHome feature stores a unique position (*HOME*) in the Multi-Navigator’s

memory. This unique feature allows for quick and easy navigation

to the *HOME* position using the GPS and Compass functions of the Multi-

Navigation System (MNS). *HOME* is automatically recorded and named by

pressing and holding the WPT button.

The following is a simple example of the use of the StraightHome feature:

You plan to walk to Cavern Hot Springs from your vehicle. You know the location of the

hot springs, but after a relaxing soak you want to be certain you can find your vehicle at

the end of the day.

2.1 -- Storing * HOME *

1. Near your vehicle, find an open area (without tree cover).

2. Power on the Multi-Navigator by pressing and holding ON.

Wait for display to change from ACQUIRE to POSITION

(Fig. 2). This will take approximately 2-3 minutes the first
time the Multi-Navigator calculates your position.

Figure 1

BRUNTON

Figure 2