Hitachi 20cx20b501 Manual De Propietario

VCR and Cable Box Codes Index 

- 15 - 

seconds, try a different 2-digit preset code. 
5.   The remote will now control your VCR. 

NOTES: 
•     If your VCR cannot be operated after performing the above procedures, this means that your 
VCR codes have not been precoded into the remote. 
•     In the unlikely event that your VCR cannot be operated after performing the above 
procedures, consult your VCR operating guide. 
•     The remote control will remember the codes you have programmed in the unit the batteries 
are removed from the remote control. After replacing the batteries repeat the entire programming 
procrdure stated above. 
•     If your VCR does not have a power function, the remote will issue the CHANNEL UP function. 

1.  Turn on your cable box. 
2.  Aim the remote control at the front of your cable box. 
3.  Press the cable box button to switch to the cable box precoded mode. 
4.  While holding down the CABLE button, enter the 2-digit preset code that matches your cable 
box.* The remote will turn on your cable box when the correct 2-digit code is entered. When this 
occurs, the remote control is programmed for your cable box. If the Cable Box does not turn off 
after 5 seconds, try a different 2-digit preset code. 
5.  The remote will now control your Cable Box. 

NOTES: 
•     If your cable box cannot be operated after performing the above procedures, this means that 
your cable box codes have not been precoded into the remote. 
•     In the unlikely event that your cable box cannot be operated after performing the above 
procedures, consult your cable box operating guide. 
•     The remote control will remember the codes you have programmed in the unit the batteries 
are removed from the remote control. After replacing the batteries repeat the entire programming 
procrdure stated above. 
•     If your VCR does not have a power function, the remote will issue the CHANNEL UP function. 

•     For some models, the remote control's channel 

 and 

 will control the cable box channel. 

The number buttons will control your television channel although you are in cable mode. 

*(Codes are listed on page 14.) 

The Remote Control is capable of operating many brands of VCRs or Cable Boxes. You must first 
program the Remote Control to match the remote system in your VCR or Cable Box. 

NOTE: The Remote Control memory is limited. Some models of VCRs or Cable Boxes may not 
operate. The Remote Control is not designed to control all features that are available in all 
models.