Alpine IVA-D300 Guía Del Usuario
9
-EN
Getting Started
About the expression of buttons in this Owner's
Manual
Manual
• The buttons on this unit are expressed in bold (e.g. SOURCE/
POWER). The touch buttons on the display are expressed in
bold with [ ] (e.g. [SRC]).
bold with [ ] (e.g. [SRC]).
• This Owner’s Manual explains mainly the function of touch
buttons, when a touch button and a unit button have the same
function.
function.
Using Face Cover
An anti-theft face cover is provided with the
IVA-D300.
Put the face cover onto the IVA-D300 when you leave
the vehicle.
Be sure to remove the anti-theft face cover when you
drive.
IVA-D300.
Put the face cover onto the IVA-D300 when you leave
the vehicle.
Be sure to remove the anti-theft face cover when you
drive.
Initial System Start-Up
Immediately after installing or applying power to the
unit, it should be initialized. Press the RESET switch
with a ballpoint pen or any other pointed object.
unit, it should be initialized. Press the RESET switch
with a ballpoint pen or any other pointed object.
• If the monitor was open before resetting, it will close automatically
after a reset is performed. None of the buttons will function while it
is closing.
is closing.
!
1
2
3
4
5
67
8
9
" #
Location of Controls
1 Rotary encoder
Adjust the volume by turning to the left or right.
If pressed, the audio adjusting screen is displayed.
If pressed, the audio adjusting screen is displayed.
2 Access Indicator
Blinks when an operation is performed (except when the
volume is adjusted).
volume is adjusted).
3 Remote Sensor
Point the optional remote control transmitter toward the
remote sensor within a range of 2 m.
remote sensor within a range of 2 m.
4 SOURCE/POWER button
Turns the power on. Press and hold for at least 2 seconds
to turn the power off.
Recalls the source selection screen.
to turn the power off.
Recalls the source selection screen.
5 BAND/TEL. button
Radio mode: Changes the band.
Visual source (except navigation screen): Changes the
display mode.
Press and hold for at least 2 seconds to change to the
TEL. mode, and to be able to place or cut a call. (When
MobileHub (CXA-B200NK) is connected.)
Visual source (except navigation screen): Changes the
display mode.
Press and hold for at least 2 seconds to change to the
TEL. mode, and to be able to place or cut a call. (When
MobileHub (CXA-B200NK) is connected.)
6 V.SEL/OFF button
The visual selecting screen is displayed.
Press and hold for at least 2 seconds to cancel the
Simultaneous function.
Press and hold for at least 2 seconds to cancel the
Simultaneous function.
7 V.SEL Indicator
Lights when the simultaneous function is activated. (See
“Switching the Visual Source Only (Simultaneous
Function)” on page 25.
“Switching the Visual Source Only (Simultaneous
Function)” on page 25.
8 Reset Switch
Be sure to press the Reset switch when using the unit for
the first time, after changing the car battery, or when an
operation cannot be performed.
the first time, after changing the car battery, or when an
operation cannot be performed.
9 MUTE button
Turns the MUTE mode ON or OFF.
! DISC-IN Indicator
This indicator is lit when a disc is inserted.
" c button
Ejects a disc.
# OPEN/CLOSE/FLAT button
Raises the monitor.
Press and hold for at least 2 seconds to lower the monitor.
Press to move the open monitor to the flat position.
Press and hold for at least 2 seconds to lower the monitor.
Press to move the open monitor to the flat position.