Delfield 7048-m Instruccion De Instalación

4

5

The optional wall mount kit is designed to securely hold a 

7000 Series unit to a structurally sound wall. It meets the 

requirements as established by Underwriter’s Laboratories 

of withstanding a static load of four times the weight of the 

cabinet alone.

2 — 2" x 2" x 3/16" (5.1 cm x 5.1 cm x 0.2 cm) angled  

        aluminum brackets, 48" (121.9 cm) long
12 — #10 x 7/8" type A hex head metal screws
6 — 1/4" x 2–1/2" lag bolts
2 — stainless steel trim pieces

                        

1     Position the prepunched aluminum bracket 

on the top of the unit, flush with the back 

edge, and mark the location of the holes 

on the unit. There should be one hole 

approximately 5/8" (1.6 cm) from each end 

of the cabinet, and a third hole 8.75" (22.2 

cm) from the right end of the cabinet. Be 

sure to use the prepunched holes; screws 

in these locations tie into the internal 

support structure of the unit.

                      2     Drill 9/64" (3.6 mm) holes at the locations 

as marked. Attach the bracket to the unit 

with three of the #10 sheet metal screws.

                      3     Mount the bottom bracket to the wall.
On a stud wall, the bottom bracket should be screwed into a 

minimum of three studs with the provided 1/4" x 2–1/2" lag 

bolts. On a masonry block wall, the bottom bracket should be 

screwed into the wall at a minimum of three evenly spaced 

locations with 1/4" diameter toggle bolts (not provided).
When positioning the bottom bracket, be sure to allow at 

least 6" (15.2 cm) of clearance above and below the unit. Be 

sure the bottom bracket is level before continuing.

                        

4     Position the unit on the bottom bracket and 

attach the top bracket to the wall using the 

same method as in step 3.

                      5     Attach the bottom bracket to the unit using 

the prepunched holes and three of the #10 

sheet metal screws.

                      6     Attach the stainless steel trim strips to the 

left and right sides of the cabinet using 

three #10 metal screws on each side.

When choosing a location to mount your 9000 Series display 

case, keep in mind that the entire unit must be removed from 

the wall in order to clean the condenser. This must be done 

on a regular basis, in most cases not longer than every three 

months. Install the equipment in a location that will allow 

easy removal for cleaning.

                         1     Two wall brackets are supplied with 36" and 48" 

long units; three brackets are supplied with 60" 

and 72" long units. Lag bolts are not supplied 

(see below for recommended sizes). Use all 

brackets provided for a secure installation.

On a stud wall, the brackets should be screwed into two 

studs with 1/4" lag bolts so that 2.50" (6.4 cm) of the lag 

bolt engages the stud. On a masonry block wall, the brackets 

should be screwed into the wall at two evenly spaced loca-

tions with 1/4" diameter toggle bolts.
When positioning the brackets, be sure to allow at least 6" 

(15.2 cm) of clearance above and below the unit.

                        

2     After the brackets are attached to the wall 

with one bolt in each, check that they are 

level. Finish mounting the brackets.

                      3     Once the brackets are secure, lift the unit 

into place and engage the angle bracket on 

the back of the unit into the wall brackets.