Maytag mmv4205b Instruccion De Instalación

Place the blower unit back into the opening.

CAUTION: Do not pull or stretch the blower unit 
wiring. Make sure the wires are not pinched. 
NOTE: The blower unit exhaust openings should 
match exhaust openings on rear of microwave 
oven.

Secure the blower unit to the microwave with the 
screw.

Attach the exhaust adaptor to the rear of the oven 
by sliding it into the guides at the top center of the 
back of the oven.

Push in securely until it is in the lower locking tabs. 
Take care to assure that the damper hinge is installed 
so that it is at the top and that the damper swings 
freely.

FOR EASIER INSTALLATION AND PERSONAL 
SAFETY, WE RECOMMEND THAT TWO PEOPLE 
INSTALL THIS MICROWAVE OVEN.

NOTE: If your cabinet is metal, use the nylon 
grommet around the power cord hole to prevent 
cutting of the cord.

NOTE: We recommend using filler blocks if the 
cabinet front hangs below the cabinet bottom shelf.

NOTE: When mounting the microwave oven, thread 
power cord through hole in bottom of top cabinet. 
Keep it tight throughout Steps 1–3. Do not pinch cord 
or lift oven by pulling cord. 

Insert a self-aligning screw through top center 
cabinet hole. Temporarily secure the oven by 
turning the screw at least two full turns after the 
threads have engaged. (It will be completely 
tightened later.) Be sure to keep power cord 
tight. Be careful not to pinch the cord, 
especially when mounting flush to bottom of 
cabinet.

End A

End B

Back of 
Microwave

Blower-Plate

From the Mounting 
Plate screw

Guide

Back of 
Microwave

Adaptor

Guide

From Blower motor screw
(after attached the exhaust adaptor)

Rotate front of oven 
up against cabinet 

bottom

Lift microwave, tilt it 
forward, and hook slots

at back bottom edge 

onto four lower tabs of 

mounting plate.