Grindmaster d-15 Manual Suplementario

ITEM

PART # / QTY PART # / QTY PART # / QTY PART # / QTY

KIT (contents listed below)

5350

5351

5352

5353

SECURITY BRACKET

2755 / (1)

2755 / (1)

2755 / (1)

2755 / (1)

SECURITY UPRIGHT

2756 / (1)

2943 / (1)

2756 / (1)

2943 / (1)

LOCKDOWN CHANNEL

2760 / (1)

2760 / (1)

2761 / (1)

2761 / (1)

SCREW, 10-24 X 3/4

0077 / (1)

0077 / (1)

0077 / (1)

0077 / (1)

PADLOCK

1503 / (2)

1503 / (2)

1503 / (3)

1503 / (3)

VALVE LOCKING BOX

3203 / (2)

3203 / (2)

3203 / (4)

3203 / (4)

LOCKING BAR

3202 / (1)

3202 / (1)

3202 / (2)

3202 / (2)

CAP NUT

0053 / (2)

0053 / (2)

0053 / (2)

0053 / (2)

5/16 SS SCREW

0061 / (2)

0061 / (2)

0061 / (2)

0061 / (2)

SECURITY CLAMP

2754 / (1)

2754 / (1)

2754 / (1)

2754 / (1)

Tools required: 1 regular blade screwdriver, 
1 Phillips screwdriver

Instructions:
UNPLUG MACHINE BEFORE INSTALLATION
1) Remove all bowls from unit.
2) Remove the left side panel and back panel.
3) Clip security bracket over the back lip of top tray

between the bowl indentations. (see drawing)

4) Reassemble back and side panel. The back panel

fits over the security bracket.

5) Situate the security clamp over the drip lip and 

tighten the screw (#0077), so the tab, located on 
the back of the security clamp, slides into the security
bracket’s slot. (see drawing)

6) Bolt the security upright onto the security clamp using 

2 cap nuts and 5/16 SS screws provided. (see drawing)

7) Reassemble the bowls on the unit.
8) Place the lockdown channel on top of bowls, making sure

the lockdown channel’s opening slips into the security
upright’s notch.

Padlock

5/16 Screw

Security Clamp

Front of Unit

Cap Nut

Back of Unit

Top Tray

Lockdown Channel

Security Upright

Security Bracket

Screw
10-24 x 3/4

Drip Lip

The valve security kit locks dispense valve to prevent use when store is closed. The bowl security kit locks the lid on
the bowl to prevent unauthorized access.

1) Place locking box underneath bowl where valve protrudes.
2) Insert locking bar through the slits on each side of the locking 

box.

• For Models E27 and E29 put the locking bar through both boxes.
• For Models E47 and E49 put the locking bar through two of 

the locking boxes from the center with the lock on the outside. 
Next, install the two other boxes from the outside to the center.

3) Place the padlocks into the hole on each locking bar and lock.
NOTE: Kit designed for “cup activated” handle (pictured). Kit will
not work with “non-contact” handle.

Valve

Handle